HBR1HF Mono Band 20m HF Transceiver.
This is a completely assembled and tested homebrew mono band transceiver with specifications:
*. Heterodyne using 11.059200 MHz Xtal filter based on Hambuilder BritX exciter
*. ADE-1 mixer
*. 20m Band coverage
*. SSB & CW modes
*. 2x IRF 520 Final RF amplifier
*. up to 25 watts RF power output (max power in CW Mode)
*. CW mode using 700Hz tone modulation generated by microcontroller
*. 16×2 char LCD
*. Si5351 VFO and BFO synthesizer based on RTCMono controller
*. Dimensions 150 x 150 x 56 mm
Band Coverage :
*. 20m (14.000.000 – 14.500.000), 9-15 MHz BPF, 15 MHz LPF
*. Bands range are programmable, as long as not cross the BPF/LPF range
The packet consist of :
*. HBR1HF Transceiver set
*. Condenser Microphone
*. DC Cord
*. Supply VCC: 12-13.8V, 6A (TX), 0.3 (RX)
** Shipped assembled, pre-programmed, fully tested, and in working condition.
** Purchasing this Product means being prepared to comply with the applicable requirements & policies.
** This is a home-brew Product and is designated for personal use only.
** Adequate knowledge in radio electronics is required in using this Product.
** Hambuilder is not liable for any damage or error caused by user’s failed experiments and/or learning process.
** For those of you who have difficulty in assembly and want to discuss about products that suitable to your electronic project, please contact our team via message inbox or via email to : support (at) hambuilder (dot) com